|
|
|
Heated Walkway Mats
 The
Heated Walkway Mats are designed to prevent snow and ice accumulation
around the home or facility. They plug into any standard 120V outlet
generating heat to melt snow at a rate of 2" per hour. The mats are
built with non-slip; UV protected reinforced rubber, and is designed to
be left outside for the entire winter season. The Walkway Mats come with
grommet holes on each side (approximately every three feet) to help
secure them in place. Units come with a 6’ cord. Approval drawing will
be completed upon ordering, to ensure power cords are in correct
position. Other sizes and applications available, contact factory.
|
Heated Walkway Mats |
| Model |
Size
(WxL) |
Watts |
Amps |
Net Wt.
(lbs) |
| WHM-2460 |
24"x5' |
301 |
2.5 |
20 |
|
WHM-24120 |
24"x10' |
635 |
5.3 |
39 |
| WHM-3660 |
36"x5' |
457 |
3.8 |
33 |
|
WHM-36120 |
36"x10' |
964 |
8.0 |
66 |
Heated Stair Mats
 The Heated Stair Mats
are designed for industrial use. Built with non-slip, UV protected
rubber, they can endure harsh weather and be left outside for the entire
winter season. The mats plug into any standard 120V outlet generating
heat to melt snow at a rate of 2" per hour. The stair mats can either
come as a single mat or linked together in a set of multiple stair mats.
Each stair mat is designed with watertight connector cables enabling it
to connect to additional stair mats. A customer can connect up to 10
stair mats on a single outlet. Each set comes with one power supply cord
(6’). The mats come with grommet holes in every corner (and every three
feet of length depending on the size) to help secure them in place.
Approval drawing will be completed upon ordering, to ensure power cords
are in correct position. Other sizes and applications available,
contact factory.
|
Heated Stair Mats |
| Model |
Size
(WxL) |
Watts |
Amps |
Net Wt.
(lbs) |
| SHM-1136 |
11"x3' |
70 |
0.6 |
6 |
| SHM-1148 |
11"x4' |
96 |
0.8 |
8 |
Heated Mat Accessories
 The TST-120
plugs directly into any 120V outlet, and then acts as an outlet
receptacle itself. Once plugged in, a heated mat can plug directly into
the back of the thermostat. When installed, the convenient TST-120
automatically energizes the mat at temperatures lower than 38°F/ 3°C and
then shuts off power when the temperature rises to 50°F/ 10°C. It has a
power indicator light that lights up when the thermostat is energized.
This is designed only for 120V products, and can handle up to 15 Amps.
 The STS-120
snow switch is an energy saving alternative to thermostat, manual or
timer controls. It operates the heated mats when precipitation occurs at
temperatures below 38°F (3.3°C) and remains energized for 5 hours after
precipitation stops to ensure complete ice/snow melting. The STS-120
snow switch operates from 120Vac, 50/60 Hz. An integral relay rated for
120/240Vac 16 Amp loads permits direct heater control for small
applications such as wheelchair ramps and stairways or may operate
external contactors in large installations. The STS-120 is hardwired
into a circuit and is not a plug-and-play like the TST-120. For best
results, the STS-120 should be mounted at least six feet off the ground
with nothing hanging over it (i.e. an overhang, awning, etc.).
|
Heated Mat Accessories |
| Model |
Description |
Size |
Amps |
Net Wt.
(lbs) |
| TST-120 |
Thermostat |
6"X2"X2" |
15 |
2 |
| STS-120 |
Snow and Temperature
Sensor |
8"X8"X6" |
16 |
5 |
back to top^
|
|
|
|
|
|
