Dock Seals
- Combines the advantage of low cost and excellent sealing action
- Designed for maximum energy savings with long-lasting features
For use with an 8'W x
8'H (D-150-XX) or 8'W x 9'H (D-350-XX) door. Superior 36 oz. nylon
reinforced vinyl facing has a higher tear strength than equivalent weight
hypalon. Chemically sealed ends prevent moisture infiltration. Full height
air escape tunnel. Mounted and bonded on durable wolmanized wood. 2" nylon
reinforced guide stripes. Through the wall installation kits included.
Three piece construction: top - 12" high; sides - beveled sides with 91⁄2"
width at the wall and 12" width at the face. 5" maximum compression is
recommended. Applications with a flush dock to building in conjunction with
an Edge-O-Dock use a 20" projection Dock Seal. To ensure proper size
complete and fax the survey sheet shown on page 8. Units are non-returnable.
Print and fax this
Dock
Seal & Shelter Survey Sheet (pdf) to the factory for a error free quote.
Dock Seal/Shelter Combinations
For use with an 8'W x
10'H door. Top (header) is constructed of wolmanized lumber and is built
with a slope to allow for water run-off. Header measures 114"W with a
30" drop curtain. Side (verticals) measure 120" tall and contain high
density foam mounted to treated lumber. Once mounted, the face of the
vertical will measure 12"W and will taper to 91⁄2" at wall. Verticals
are mounted on wooden 2" x 12" to allowing wall mounting down the length
of the vertical pieces. Applications with a flush dock to building in
conjunction with an Edge-O-Dock use a 20" projection Dock Seal. Units
are non-returnable.
Print and fax this
Dock Seal & Shelter Survey
Sheet (pdf) to the factory for a error free quote.
Dock Shelters
For
use with doors up to 10'W x 10'H. Reduces oversized doors to match truck
opening. Long wear Vestex V-42 fabric is highly resistant to abrasion
and tearing. Fiberglass staves are sewn into the flaps. Seal is formed
along the sides and top of trailer when the vertical and top panels are
pushed inward by the trailer. Recommend minimum 10" trailer penetration
for a good seal. Supporting structure is made of 2 x 4 wolmanized
lumber. Shelter is protected by safety yellow steel guide protectors.
The top header piece measures 132"W and contains a drop curtain which
measures 36"H. Two vertical pieces measure 126" tall with vertical flaps
measuring 21"W. When installed the shelter will close door opening down
to 90"W x 90"H opening (between flaps). Includes two yellow steel guide
protectors and foam-filled corner pads for extra sealing action.
Print and fax this
Dock Seal & Shelter Survey
Sheet (pdf) to the factory for a error free quote.
Retractable Dock Shelter
The Retractable Dock
Shelter fits up to a 120"W x 120"H door. Independent spring loaded
scissors mechanism allows shelter to retract with the trailer keeping
the shelter square. The design also eliminates the need for rigid steel
guide protectors. Overall size 132"W x 126"H x 24" projection. The 40
ounce reinforced vinyl flaps close the opening down to 90" x 90". The
36" header curtain has armor pleats for extended wear. Shelter is black
with aluminum edge trim.
Print and fax this
Dock Seal & Shelter Survey
Sheet (pdf) to the factory for a error free quote.
